28 Matrix SETU ATA211 V1 System Manual
• Click on 'Peer to Peer Call Table'. Program the number (say, 3001) assigned to the FXS port of the
ATA211 located at Location B.
• Program the IP Address of broadband modem/router located at the Location B.
• If the users are comfortable dialing IP addresses directly after lifting the handset, peer-to-peer table
need not be programmed.
5. Program following parameters (for Lcoation B)
• Click on 'Peer to Peer Call Table'. Program the number (say 2001) assigned to the FXS port of the
ATA211 located at Location A.
• Program the IP address of broadband modem/router located at the Location A.
• If the users are comfortable dialing IP addresses directly after lifting the handset, peer-to-peer table
need not be programmed.
Corporate Users - Scenario3: (refer Fig. 5 - When ATA211 is connected behind the
Broadband router with NAT type 'Symmetric' at both the locations.)
Following steps should be done at both the locations:
Configure the Broadband Router at both locations as follows:
1. Forward SIP listening port of client (e.g., 5060 for both Routers) in Router to IP address of WAN port of
ATA211 connected behind the respective router.
2. Forward RTP listening port in Router (to WAN IP address of ATA211 which is connected behind the
respective router).
Configuring ATA211:
1. To access Jeeves using computers to WAN port of ATA, ensure that the WAN port of ATA211 and the
computers in the LAN are in the same subnet. The default WAN IP address of ATA211 is 192.168.001.171
and the subnet mask is 255.255.255.0.
2. Change the IP address and the subnet mask of the WAN port of ATA211 (if required) using telephone
instrument.
Please refer topic “Programming Options”.
3. Program following parameters (for both locations):
• Open web Jeeves of ATA211 by entering the WAN IP address of the ATA211 in the URL field and press
Enter.
• Login as 'Admin' into the Jeeves of ATA211 using the Admin password (default 1234) you will reach the
Home page.
• Click on 'WAN Port' link and enter the values of IP address, Subnet mask, Gateway and DNS address
in the respective fields.
• On the 'WAN Port' page, also program the parameter 'Use SIP port fetched using STUN?' as 'No' (by
default it is 'YES').
• Click on 'SIP Accounts' and program 'Enable SIP Account' for the SIP Account which is to be used.
Program he parameter 'SIP Id' for this SIP Account as '*' (for configuring it as P2P Account).
• On 'SIP Account s', configure the parameter 'Use Symmetric RTP? as 'Yes' for the SIP Account to be
used.
4. Program following parameters (for Location A):
• Click on 'Peer to Peer Call Table'. Program the number (say, 3001) assigned to the FXS port of the
ATA211 located at Location B.
• If the users are comfortable dialing IP addresses directly after lifting the handset, peer-to-peer table
need not be programmed.
To Next Page
Loading...
Need help?
General
