Matrix WellMate - Overwrite a Locked Program

30
Setting up and running the Instrument
3. Press SELECT. “LoAd” appears on the
display.
b. Press START. The volume set for that program
will appear on the display.
c. Press START again, this will run the selected
program.
5. Overwrite a Locked Program
1. Press MODE until the memory LED is illuminated.
2. Select the desired program number using the UP
and DOWN arrows.
a. Press SELECT “LoAd” appears on the display.
b. Press SELECT again, PASS appears on the
display if the program is locked.
c. Press PRIME button. “----“ appears on the display.
d. Use the UP or DOWN arrows to input the 4-digit
password for that program. Pressing PRIME to
select the number for each digit.
e. Once the password is on the display, press
START to unlock the program.
f. If the password is correct, SAVE appears on the
display.
g. Press MODE to select the volume and pattern to
overwrite the program.
h. If the password for that program is incorrect, then
the display does not change. Go through the
steps again to re-enter the correct password.
i. Repeat steps to lock the program.