Matrix WellMate - Default Chapter; Table of Contents

To Next Page

To Previous Page

Contents

III

Table of Contents

A. INTRODUCTION ...................................................... 1

B. INSTRUMENT OVERVIEW ...................................... 2

1. General Description .......................................................2

2. Keypad and LED Display ...............................................6

3. Stacker Unit ...................................................................8

4. Speciﬁ cations.................................................................9

5. Hazards/Precautions ...................................................12

C. CONFIGURING THE DEVICE ................................ 13

1. Install the Tubing Cartridge ..........................................13

2. Attach the Removable Plate Carriage/Stage ...............16

3. Attach the Waste-Fluid Vessel .....................................17

4. Set Up Plates ...............................................................18

5. Install Stackers (optional) ............................................21

6. Attach the Power Cord.................................................23

D. SETTING UP AND RUNNING THE

INSTRUMENT ........................................................ 24

1. Prime the Tubing Cartridge ..........................................24

2. Create, Load and Save a Program in Memory ............25

3. Run a Program From Memory .....................................27

4.Program Lock Freature Instructions ...............................29

5. Overwrite a Locked Program.........................................30

6. Set Up and Operate Stacker Base Unit .......................31

7. Operate the Instrument Manually ................................33

8. Adjust the X-Axis Stage Position .................................34

9. Adjust the Dispensing Speed.......................................36

10. Additional Functions ....................................................37

E. TUBING CARTRIDGE MAINTENANCE

AND RECALIBRATION .......................................... 39

1. Clean the Tubing Assembly .........................................39

2. Recalibrate the Tubing Cartridge If Necessary ............40

F. HELPFUL HINTS .................................................... 43

G. TROUBLESHOOTING ........................................... 44