Matrix WellMate - Run a Program from Memory

27
Setting up and running the Instrument
®
b. To change the current selection of the column
used from on to off or off to on, press SELECT.
The digit will be toggled to the other value, either
“0” or “1”.
c. Press the up or down arrow to move to another
column.
d. Continue to press SELECT to toggle dispense on
or off for each column.
4. Save the program:
a. Press MODE. The MEMORY LED lights up.
b. Press the up or down arrow to move to the
program number you want to save this program
to. If you are using a 96-well plate, program
numbers 1–9 appear, one at a time, in the display.
If you are using a 384-well plate, numbers 11–19
appear in the display.
When the program number you want to use appears
in the display, press SELECT. “LoAd” appears
in the display. Press SELECT again. “SAVE”
appears in the display.
c. Press START. PASS appears on the display.
d. Press MODE. The programmed dispense volume
will appear on the display.
e. Press START to run the program.
3. Run a Program From Memory
1. Ensure that the supply ends of the channel tubes
are in the container with the agent to be dispensed.
2. Ensure that the waste-fl uid vessel is in place and
that the waste-fl uid tube is placed in a waste liquid
container, with the open tube end ABOVE any
waste liquid in the container.