Connecting video sources 29
Connecting video sources
Connecting to Matrox Solios eV-CLB or Matrox Solios eV-CLF
boards
The Matrox Solios eV-CLB and Matrox Solios eV-CLF boards have the following
connectors on their bracket:
• Two mini Camera Link-compliant video input connectors. Used to receive video
input, timing, and synchronization signals and transmit/receive communication
signals between the video source and the frame grabber.
• External auxiliary I/O connector 0 (DBHD-15). Used to transmit/receive
auxiliary signals for one of the acquisition paths. By default, it carries the auxiliary
signals for acquisition path 0; if a jumper is installed on the 2-pin I/O acquisition
path jumper block, the auxiliary I/O connector carries the auxiliary signals for
acquisition path 1.
• Internal auxiliary I/O connectors (16-pin and 10-pin). Used to transmit/receive
auxiliary signals. The connector is located on the edge of the board, making the
signals accessible from inside the computer enclosure.
To Next Page
Loading...
