Max Bepop CPM-200G User Manual

12
Machine Preparation
AdjustingtheCuttingPressure
Cutting depth is adjusted by changing the blade pressure (cutting pressure).
The blade may cut too much or fail to cut depending on the type of material, temperature, and so on.
Therefore, we recommend advance testing and adjustment of the cutting pressure.
Anappropriatecuttingpressureleavesaslighttraceonthereleaseliner.
■ If the tape is not properly cut and cannot be
peeled off, the cutting pressure is set too low.
Increase the dial value, in steps of half
a graduation, so that the tape will be cut
properly.
High
■ If the release paper has also been cut (as
far as the back of the release paper), the
cutting pressure is too high.
Decrease the dial value, in steps of half
a graduation until the release paper is no
longer cut.
Low

CAUTION
Adjustthecuttingpressurebeforeuse.
Continuing to use the machine with excessive cutting pressure can reduce the service life of the
cutting tool (blade).
It would also cut the release paper and could cause the machine to malfunction.

Max Bepop CPM-200G Specifications

General

Brand	Max
Model	Bepop CPM-200G
Category	Label Maker
Language	English