Max Bepop CPM-200G - Installing (Replacing) the Cutting Tool (Blade)

11
Machine Preparation
Installing(Replacing)theCuttingTool(Blade)
1
Check that the power is turned off, and pull up the
opening/closing lever to open the door cover.
3
Prepare a new cutting tool (blade) and remove
its protective cap.
Opening/Closing Lever
Door Cover
Blade
Edge of the Blade
Protective Cap
4
Insert/drop the blade into the blade holder
and tighten the blade holder cap.
DONOT
push the blade into the holder otherwise it
will not cut correctly.
2
Move the cutting head to the center manually.
Loosen and remove the cap of the blade holder.

WARNING
Keepthecuttingtool(blade)outofthereach
ofchildren. If swallowed, seek immediate medical
attention.

CAUTION
Whenattaching orremoving thecuttingtool(blade),
besure toturn offthepower.Otherwise, you could be
injured by abrupt activation of the machine.
Donottouchtheedgeoftheblade.Youmaybeinjured.