Section 6 – Repair/Replacement
H6630EM-LIT 33 Rev. 1.0 11/14
Section 6 – Repair/Replacement
6-1 Controller Drive Unit
In the event that the H6630 drive must be replaced due to failure, refer to Installation
Instructions (IS-1293), this describes how to use the Winflash software in a PC to download
the program file to the H6630 controller using Ethernet. The program files will be supplied by
Fife Corporation on a USB flash drive, along with the Winflash software and files.
IS-1293 “Instructions for using H6630 Download Tool to download program files to the
H6630EM controller using Ethernet”; can be found in Appendix A of this manual.
6-2 Operator Interface – HMI
In the event that the HMI must be replaced due to failure, refer to Installation Instructions (IS-
1287). This will describe how to download the HMI program file to the H6630-HMI operator
interface.
IS-1287 “Instructions for downloading programs to the H6630-HMI-07” can be found in
Appendix A of this manual.
To Next Page
Loading...
Need help?
General
