Maxell MP-WU9101B - Page 43

43
Operating
Select in the INPUT MENU > PinP POSITION (53).
 Changing the position of sub area
PbyP (Picture by Picture) / PinP (Picture in Picture) (continued)
• For some signals, it may not be displayed correctly in the PbyP / PinP
mode, even if it can be displayed properly in the normal mode.
• PbyP/PinP is unavailable when ON is selected in GEOMETRY CORRECTION
> EDGE BLENDING > MODE.
• PbyP / PinP is unavailable when 3D is enabled.
NOTE
Press the MY BUTTON assigned the PbyP / PinP SWAP (
59). The position of
the both area is exchanged without any setting change.

PbyP / PinP SWAP function