Maxon GPTWR-25 - Page 38

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
38
STEP 7 - INSTALL CONTROL SWITCH - Continued
2. Insert control switch wir-
ing into the 3/4” hole on the
corner post and run it under
the vehicle body to the pump
assembly. (See dashed line
- FIG. 38-1.) Insert switch
wiring through cord grip on
pump mounting plate (FIG.
38-2). Connect the switch
wiring to the pump assembly
as shown in (FIG. 38-2).
3. Push control switch and ca-
ble back into the ¾” hole in
the vertical post until con-
trol switch cover touches
the post (FIG. 38-1). Attach
control switch to vertical
post with 2 self-tapping
screws (FIG. 38-1).
ROUTING CONTROL SWITCH WIRING
FIG. 38-1
3/4” HOLE
(2 PLACES)
VEHICLE BODY
VERTICAL POST
CONTROL SWITCH
WIRING
CONTROL SWITCH
SELF-TAPPING
SCREW, 1-1/2” LG.
(2 PLACES)
4. If necessary, use clamps
and self-tapping screws,
from installation parts
bag, to secure switch
cable to vehicle (FIG.
38-1).
CONTROL SWITCH WIRING CONNECTIONS
FIG. 38-2
SOLENOID SWITCH
POWER DOWN MODULE
WHITE WIRE
GREEN WIRE
CORD GRIP
WHITE WIRE
TO TERMINAL 1
BLACK WIRE
TO TERMINAL 2
FUSE HOLDER
ASSEMBLY