Maxon TE-15 - DECALS

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
11
VEHICLE REQUIREMENTS
• See TE-25 and TE-30 high bed installation dimensions in FIG. 14-1.
• See TE-25 and TE-30 low bed installation dimensions in FIG. 14-2.
• See TE-25 and TE-30 high bed truck frame cut-out dimensions in FIG. 15-1.
• See TE-25 and TE-30 low bed truck frame cut-out dimensions in FIG. 15-2.
NOTE: Make sure vehicle is parked on level ground while preparing vehicle and
installing Liftgate.
NOTE: Dimensions are provided as reference for fi tting Liftgate to vehicle body.
NOTE: Measure the width of the Liftgate and the width of the vehicle body before
you start doing this procedure. Ensure the Liftgate is the correct width for
vehicle.
• See TE-15 and TE-20 high bed installation dimensions in FIG. 12-1.
• See TE-15 and TE-20 low bed installation dimensions in FIG. 12-2.
• See TE-15 and TE-20 high bed truck frame cut-out dimensions in FIG. 13-1.
• See TE-15 and TE-20 low bed truck frame cut-out dimensions in FIG. 13-2.
NOTE: The vehicle bed height for TE-Series high bed Liftgates is 54” maximum
(unloaded) and 42” minimum (loaded). For the TE-Series low bed Lift-
gates, the bed height is 44” maximum (unloaded) and 36” minimum (load-
ed). Do not install this Liftgate on vehicle bodies equipped with swing open
doors.