11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
17
STEP 1 - INSTALL EXTENSION PLATES
NOTE: TE-15, TE-20, TE-25 & TE-30 Liftgates may be equipped with two types of
extensions plates. The weld-on extension plate is shown in FIG. 17-1.
The bolt-on extension plate (FIG. 17-2) has bolt holes so it can be bolted to
vehicle body. GRADE 8 bolts are required. MAXON recommends getting
the optional extension plate hardware kit listed in OPTIONS section. It also
has holes for bolt-on steps and installation brackets, provided with compo-
nents for installation. Refer to the following instructions for installing exten-
sion plates.
WELD-ON EXTENSION PLATE
FIG. 17-1
BOLT-ON EXTENSION PLATE
FIG. 17-2
To Next Page
Loading...
