EasyManua.ls Logo

Maxon TE-15 - Step 4 - Run Power Cable

Maxon TE-15
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
39
STEP 4 - RUN POWER CABLE
1. Liftgate powered from
truck batteries is typically
installed on trucks as
shown in FIG. 39-1. See
the following page for
running the battery cable.
LIFTGATE
LIFTGATE
POWER UNIT
RECOMMENDED LIFTGATE & BATTERY BOX
INSTALLATION ON TRUCK
FIG. 39-1
NOTE: Make sure the Liftgate power unit, and all batteries on the vehicle for the
power unit, are connected correctly to a common chassis ground.
TRUCK BATTERIES,
TYPICAL LOCATION
175 AMP
FUSED CABLE
RECOMMENDED CONFIGURATION

Table of Contents

Other manuals for Maxon TE-15

Related product manuals