Maxon TE-15 - Step 12 - Platform Adjustment (if Required)

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
58
STEP 12 - PLATFORM ADJUSTMENT (IF REQUIRED)
“A”
(TABLE 58-1)
PLATFORM EDGE
ABOVE BED LEVEL
FIG. 58-2
SHACKLES DO NOT TOUCH GROUND
FIG. 58-3A
PLATFORM & SHACKLES
TOUCH GROUND
FIG. 58-1
2. Make sure platform is still at ground level. If
the shackle is not touching the ground, mea-
sure and compare distance “A” (FIG. 58-3A)
with TABLE 58-1 to determine the correct
shim. Next, mark position on shackle (FIG.
58-3B).
1. Make sure platform is at ground level. Unfold
the platform and fl ipover. As the platform fi rst
touches the ground, shackles and tip of fl ipover
must touch the ground at the same time (FIG.
58-1). If the shackles and the tip of fl ipover
touch the ground at the same time, raise plat-
form to bed height. Outboard edge on top of
fl ipover should be above bed level (FIG. 58-2).
If indications are correct in both cases (FIGS.
58-1 & 58-2), Liftgate is installed correctly and
no adjustment is needed. If indications are
incorrect, continue with instruction 2.
LEVEL LINE
TIP OF
FLIPOVER
OUTBOARD
EDGE
NOTE: Before doing the following procedure, make sure vehicle is parked on level
ground.
RAISE TIP OF
FLIPOVER
THIS DISTANCE “A”
REQUIRED SHIM
THICKNESS
WELD
SIZE “W”
9/16” 1/16” 1/16”
1-1/4” 1/8” 1/8”
1-15/16” 3/16” 3/16”
2-5/8” 1/4” 1/4”
NOTE: If tip of fl ipover touches fi rst
(FIG. 58-3A), do instructions 2
and 3. If the shackle touches
fi rst (see FIG. 60-1), skip 2 and
3 and do instructions 4 and 5.
SHIMS TO RAISE TIP OF FLIPOVER
TABLE 58-1
MARKING SHIM
POSITION
FIG. 58-3B
1/4”
SHACKLE
PLATFORM STOP
MARK HERE