11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
44
NOTE: If there is a grounding point on the frame, use it to connect ground cable.
Then, skip the step for drilling a hole.
4. Extend the ground cable to reach
vehicle frame (FIG. 44-2) without
putting tension on cable (after con-
nection). Connect to an existing
grounding point if available.
6. Bolt the ground cable terminal
lug to vehicle frame as shown in
FIG. 44-2.
NOTE: Clean the ground cable connection point on the frame down to bare metal.
5. If necessary, drill a 11/32” (0.343”)
hole in vehicle frame for bolting
the ground cable terminal lug
(FIG. 44-2).
FIG. 44-2
TERMINAL LUG
(GROUND CABLE)
5/16"-18 X 1" LG
CAP SCREW
5/16” FLAT
WASHER
5/16”-18
LOCK NUT
VEHICLE CHASSIS
(TRUCK FRAME SHOWN)
BARE
METAL
STEP 6 - CONNECT GROUND CABLE - Continued
To Next Page
Loading...
