177
Controls in detail
Control system
Setting daytime running lamp mode
(USA only)
Move the selection marker with
button æ or ç to the
LIGHTING
submenu.
Press button j or k repeatedly
until you see
LIGHTING CIRCUIT HEAD-
LAMP MODE
in the multifunction dis-
play.
The selection marker is on the current
setting.
Press button æ or ç to select
MANUAL
or daytime running lamp
(
CONSTANT
) mode. This function is not
available in countries where daytime
running lamps are mandatory.
With daytime running lamp mode acti-
vated and the exterior lamp switch in po-
sition M or U, the low beam
headlamps are switched on when the en-
gine is running.
In low ambient light conditions the fol-
lowing lamps will switch on additionally:
Parking lamps
Tail lamps
License plate lamps
Side marker lamps
For more information on the daytime
running lamp mode, see "Lighting"
(
page 145).
i
This function is not available in coun-
tries where the daytime running
lamp mode is mandatory and there-
fore in a constant mode.
i
If you turn the exterior lamp switch to
another position, the respective
lamp(s) will switch on.
For safety reasons, resetting
the
LIGHTING
submenu to factory set-
tings (
page 173) while driving will
not reset the daytime running lamp
mode.
In the display you will then see the
message:
LIGHTING – CANNOT BE COM-
PLETELY RESET TO FACTORY SETTINGS
WHILE DRIVING.
To Next Page
Loading...
