26
Rewinder RW500
Basic safety instructions
General safety instructions
• After completion of the work, do not leave any tools or other loose ob-
jects lying on the machine.
2.9.5 Maintenance and repair
• Maintenance and repair work may only be performed by specially
trained technical personnel.
• Inform operating personnel before beginning service and maintenance
work. Secure the service area if necessary.
• For all repair and maintenance work, heed the switch-on and switch-off
procedures according to the operating manual.
• Heed the prescribed maintenance and maintenance intervals according
to the operating manual.
• If the machine is switched off for service and/or maintenance work, it
must be secured against unauthorized or inadvertent switching on
again. Use a padlock to secure the main switch against switching on. If
necessary, attach a warning sign to the main switch.
• If the dismounting of protective devices is necessary during mainte-
nance and repair work, it must be replaced and checked to make sure
it is functional immediately after completion of the work.
• After completion of the work, do not leave any tools or other loose ob-
jects lying on the machine.
• All operating and consumables as well as spare parts no longer needed
must be disposed of safely and in environmentally-appropriate fashion.
2.9.6 Work on electrical equipment
• Only an electrically qualified person is permitted to perform work on the
machine's electrical system.
• In case of faults in the electrical power supply, the machine must be
switched off immediately.
• Only use original fuses with the prescribed amperage.
To Next Page
Loading...