38 Medit T-series User Guide
Select this option if you use ARTEX articulator.
Select this option if you use KAVO articulator.
Select this option if you use SAM articulator.
Select this option if you use MARK330 articulator.
Select this option if you use A7+ articulator.
Scanning Mandibular Base
Having chosen the articulator type, you will be asked to choose how you would like to scan the
mandibular base.
Select this option to use the articulator jig to install the
mandibular base and move it to the position of the virtual
articulator.
In case there is no articulator jig, a part of mounting plate can be
used for data alignment and moving the model to the virtual
articulator.
▷ [Example] Articulator Jig Usage Example
➢ The scan steps are as following:
To Next Page
Loading...
