5.2 Main blocks of front
panel
❷ 4
6
5
➊ ➌
The main blocks of the front panel are:
1. Main power supply
2. SDRM (option)
3. Sequencer.
4. TIMING/ (MOTION / USB option)
5. Printer
6. Display and keyboard
Chapter 6 (Front panel) describes the panel function.
Main power supply
The power supply block is equipped with a fuse, a
main switch, the connector for mains voltage, ground
terminal and mains voltage switch 115 V/230 V.
Sequencer
The sequencer block is equipped with fuses for
breaker control outputs and close and trip coil inputs/
outputs.
There is also a built-in galvanically isolated analog
current transducers to measure the current in the trip
and the close circuit. AC and DC current up to 50 A is
measured.
Time/motion/USB inputs
The time/motion/USB input block is equipped with
inputs for measuring time and motion and a USB
communication terminal.
Printer
The printer block is equipped with a built-in printer
for printing results and test conditions, numeral and
graphical.
Display and keyboard
The display shows the settings and test results and the
keyboard is used for entering control parameters via
the menu system.
BM0087OE ZP-BM01E EGIL
19
5 DESCRIPTION
To Next Page
Loading...
Need help?
General
