IMPORTANT
1. DISCONNECT the power adapter before any cleaning or maintenance.
2. Maintenance should be performed only by qualied personnel familiar with the hazards
involved with high-voltage test equipment.
3. Refer all servicing to qualied personnel.
4. Routine maintenance is all that is required for these test sets. The cables and connector
panel should be inspected frequently to be sure all connections are tight and all ground
connections intact.
5. The appearance of the test set can be maintained by occasional cleaning of the case, panel,
and cable assemblies. The outside of the carrying case can be cleaned with detergent and
water. Dry with a clean, dry cloth. The control panel can be cleaned with a cloth dampened
with detergent and water. Do not allow water to penetrate panel holes, because damage
to components on the underside may occur. A household all-purpose spray cleaner can be
used to clean the panel. Polish with a soft, dry cloth, taking care not to scratch the display
screen cover. The cables and mating panel receptacles can be cleaned with isopropyl or
denatured alcohol applied with a clean cloth.
2.12. Battery inside
▪ This product is not intrinsically safe. Do not use in an explosive atmosphere
▪ This instrument contains a lithium battery.
▪ Do not pierce, damage, disassemble or modify the battery.
▪ The battery contains safety and protection devices, which if tampered with may cause the battery to
generate heat, rupture or ignite.
▪ If the battery is suspected to be faulty – do not ship it, either separately or inside an instrument.
▪ The instrument must be powered o and securely packaged before shipping.
▪ Do not heat or dispose of the battery in a re.
▪ Do not subject the battery to strong impact, mechanical shock or excessive heat.
▪ Do not short-circuit or reverse the polarity of the battery.
General safety
12 FRAX-series www.megger.com
To Next Page
Loading...
Need help?
General
