Megger Programma Sverker 760 - Sverker Ammeter Settings; Ammeter AC;DC and Unit Settings; Ammeter Range Settings; Sverker Voltmeter Settings

34
SVERKER 750/760
Programma Electric AB
ZP-CD01E R05A
rofsnoitpouneM
cdVcdA
)tnemerusaemCD(
noitanalpxE
enoNnoitcnuftnemerusaemartxeoN
deyalpsid
(R Ω)deyalpsidecnat
siseR
)W(PdeyalpsidrewoP
rofsnoitpouneM
caArocaVcdA
dexim(cdV
)tnemerusaem
noitanalpxE
eciohcoNnoitcnuftnemerusaemartxeoN
deyalpsid
1. Press the SEL button to invoke the se-
lected option.
5.9
ΩΩ
ΩΩ
Ω ,
ϕ ϕ
ϕ ϕ
ϕ , W , VA...
(Extra measurement)
ΩΩ
ΩΩ
Ω,
ϕϕ
ϕϕ
ϕ, W, VA. . .
<None>
Here, you can select extra measurement functions
(in addition to the voltage and current functions)
For all extra measurement functions, Sverker must
be set for AC measurement, i.e. for AC Amp and
AC Volt. However, this does not apply to the
measurement of resistance or active power. For
these, DC measurement can also be used.
Either voltage or current can be used as a reference
for calculating the phase difference (phase angle)
between current and voltage.
Then, when Sverker is used in the generation mode
(normal mode), the selected extra measurement
function is displayed at the top of the window,
beside the time.
Only one option can be selected at a time.
rofnoitpouneM
caVcaA
)tnemerusaemCA(
noitanalpxE
enoNnoitcnuftnemerusaemartxeoN
deyalpsid
(Z °,Ω )elgnaesahpdna
ecnadepmI
deyalpsid
(Z Ω)tuohtiwdeyalpsidecnadepmI
elgnaesahp
(X,R Ω, Ω)ecnatcaerdnaecnatsiseR
deyalpsid
)W(Pdeya
lpsidrewopevitcA
)AV(SdeyalpsidrewoptnerappA
)rAV(QdeyalpsidrewopevitcaeR
soc ϕ deyalpsidrotcafrewoP
ϕ )ferI,°
(
htiwdeyalpsidecnereffidesahP
ecnerefersatnerruc
ϕ )ferU,°(
htiwdeyalpsidecnereffidesahP
ecnerefersaegatlo
v