Megger Programma Sverker 760 - Troubleshooting Error Messages

67
SVERKER 750/760
Programma Electric AB
ZP-CD01E R05A
9 Specifications
The voltage outputs of the current
source
egnaRdaol-oN
,egatlov
muminim
daol-lluF
,egatlov
muminim
daol-lluF
-,tnerruc
mumixam
daol-lluF
,emit
mumixam
yrevoceR
,emit
muminim
V052-0
CA
V092
CA
V052
CA
A3
CA
01
setunim
54
setunim
V003-0
CD
V023
CD
V052
CD
A2
CD
01
setunim
54
setunim
The DC voltage output provides rectified, smoothed
AC. The maximum current should not be used while
any of the current outputs are being used.
NOTE! Time-limited (max-time) generation
should be used for times shorter than 1
minute.
Separate AC voltage source
This output is protected by a PTC resistor.
Moreover, it is equipped with two 400 V transient
voltage suppressors (transils). One is located
between the output contacts, and the other between
the output contact marked with a dot and ground
(earth).
057rekrevS
egnaR
)CAV(
daol-oN
,egatlov
)CAV(nim
daol-lluF
,egatlov
)CAV(nim
daol-lluF
,tnerruc
)CAA(xam
06-0
)V01fospets(
070652.0
021-06
)V01fospets(
03102152.0
067rekrevS
egnaR
)CAV(
daol-oN
,egatlov
)CAV(nim
daol-lluF
,egatlov
)CAV(nim
daol-lluF
,tnerruc
)CAA(xam
031-0541031ylsuounitnoc52.0
etunim1/53.0
-esahP
elgna
noituloseRycaruccA
°953-0°1°2±
9.1 General
The following specifications are for an ambient
temperature of +25°C (+77°F) and nominal input
voltage. Sverker is designed to comply with EU
standards as set forth in IEC 1010 and also with EU
EMC directives.
The specifications are subject to change without
notice.
Maximum load times for different currents
egnaR
)CAA(
tnerruC
)CAA(desu
,emitdaoL
mumixam
yrevoceR
,emit
muminim
)setunim(
001002)semit3(s15
051)semit5(s301
001e
tunim151
57setunim0154
05setunim03001
03suounitnoC–
0408)semit3(s15
06)semit5(s301
04etunim151
03setunim0154
02setunim03001
21suo
unitnoC–
0102)semit3(s25
51)semit5(s501
01setunim251
5.7setunim5154
5suounitnoC–