Megger Programma Sverker 760 - Measurement Specifications for Voltage (Volts); Measurement Specifications for Voltage (Percentage); Reclosing Test Specifications; Sverker Measurement Specifications

71
SVERKER 750/760
Programma Electric AB
ZP-CD01E R05A
Specifications for voltage displayed in volts
egnaRnoituloseRycaruccA
)Vm+gnidaerfo%(
CAV6:CAV999.5-00.0
CAVm01
)Vm01+%1(±
CAV06:CAV99.95-00.6
CAVm01
)Vm02+%1(±
CAV006:CAV99.99-00.06
CAVm01
:CAV9.99
5-0.001
CAVm001
)Vm002+%1(±
CDV6:CDV99.5-00.0
CDVm01
)Vm01+%5.0(±
CDV06:CDV99.95-00.6
CDVm01
:CDV99.99-00.06
CDV
m01
)Vm02+%5.0(±
CDV006:CDV9.995-0.001
CDVm001
)Vm002+%5.0(±
Specifications for voltage displayed as a
percentage of a presettable nominal value.
noituloseR
egatnecreP
noituloseR
eulavlanimoN
ycaruccA
%1:%999-000A1:A999-000%1±
Reclosing test
mumixaM
forebmun
sgnisolcer
gnitsetxaM
llarofemit
sgnisolcer
xamtanoituloseR
emitgnitset
semit94s999s1
Extra measurements
Power factor and phase angle
measurements
The following specifications are for voltages and
current readings that are higher than 10% of the
selected range.
tinudnametIegnaRnoituloseRycaruccA
rotcafrewoP
soc ϕ
ot)pac(99.0-
)dni(99.0+
10.040.0±
elgnaesahP
)°(ϕ
953-000 ° 1° 2± °
The following items can be measured for AC:
• cos ϕ
• ϕ in (°) with current as reference (Iref)
• ϕ in (°) with voltage as reference (° ,Uref)
Impedance- and power measurements
For these measurements, the result is calculated
using 2 or 3 items. The measurement error obtained
depends on the measurement errors for the items
included (U, I and sometimes ϕ ).
foenostneserperX(egnaR
)wolebdetsilsmetieht
noituloseR
Xm999-000100.0
X99.9-00.110.0
X9.99-0.011.0
X999-0011
Xk99.9-00.101
Xk9.99-0.01001
Xk999-0010001
For AC, the following items (X above) can be
measured:
•Z (Ω and °)
•Z (Ω)
• R and X (Ω and Ω)
• P (W)
• S (VA)
• Q (VAr)
For DC, the following items (X above) can be
measured:
•R (Ω)
• P (W)