Megmeet MV200 Series - Page 153

153
Fig.6-39 Example of parameter setting for pulse signal input
10V~0:0
)20mA~0(or
10V~2:1
)20mA~4(or
Fig.6-40 Analog output type selection
This function code is used for selecting the analog output range of AO1. For the voltage or current output,
it shall be determined by the jumper on the terminal board. For details, please refer to the description of
the terminal board.
The linear correspondence relationship between the AO1 output and the indication range is as shown in
Table 6-14.
Table 6-14 Analog output terminal indication
Item Function Indication range
0 Output frequency 0~Maximum output frequency
1 Set frequency 0~Maximum output frequency
2
Set frequency (after acceleration/
deceleration)
0~Maximum output frequency
3 Reserved
4 Output current
0 ~ 200% of the rated current of the
drive
5 Output current 0 ~ 200% of the rated current of the
AO1zero offset correction -100.0%~100.0%
(
0.0%
)
P10.25
AO1
g
ain 0.0~200.0%
(
100.0%
)
P10.24
Analo
g
out
p
ut terminal AO1 function 0~26
(
00
)
P10.23
Analo
g
out
p
ut t
yp
e 0~1H
(
0
)
P10.22