5�4�2 Filling the instant powder (option)
ATTENTION
Damage to the instant container cover!
The lid on the instant container cover cannot be removed.
Trying to remove the lid could damage the cover. Only
open the container cover with the machine key.
Fig. 9: Opening the instant container cover
1. Open the machine door using the key(2).
2. Lift the instant container cover(1) upwards carefully.
There will be one or two instant containers depending on
the equipment.
1
2
Fig. 10: Instant container
3. Turn the powder chute(2) upwards so that no powder
can fall out.
4. Remove the instant container(1).
5. Remove the lid on the instant container.
6. Fill the right instant powder into the corresponding
container, e.g., cocoa.
͵ Ensure that the powder is not compressed.
7. Refit the lid.
8. Refit the instant container.
9. Turn the powder chute downwards to direct it into
the mixer housing.
10. Flap down the instant container cover.
11. Close the machine door.
If the machine door has been open for more than ten
seconds, a prompt to confirm whether or not the mixer
unit should be rinsed appears on the display once the
door has been closed.
CAUTION
Danger of burns on the beverage outlet!
Hot water runs out of the beverage outlet when the
mixer unit is rinsed.
• Do not reach underneath the outlets.
12. Confirm the prompt by pressing the “Yes” button.
9 The instant container has been filled.
5�4�3 Filling the milk (option)
1 2
Fig. 11: Filling the milk container
1. Open the door of the refrigerator.
2. Fill the milk container (2) with pre-cooled milk or
prepare a container filled with pre-cooled milk.
3. Place the milk tube(1) into the container.
4. Close the door of the refrigerator.
9 The milk supply has been filled.
14
39663 • 20220101
Operation
5
To Next Page
Loading...
Need help?
General
