Page 102 www.menzimuck.com
Working with the machine
Attention !
Extending and retracting the cylinders at full speed
• Can result in damage to property.
• Move the cylinders at reduced speed to their limit positions.
Warning !
If there is an overload to the cylinders then the secondary
safeguards open and the loads can no longer be controlled
• Can result in death or severe injuries.
• Do not use the machine for work that exceeds its perfor-
mance specications.
Warning !
Tilting or stalling of the machine in water
• Can result in death or severe injuries.
• Before driving the machine into water, measure the depth of
the water and check the water bed for dangerous locations.
Attention !
Exceeding the permitted water depth
• Can result in damage to property.
• The machine may be immersed in water up to the top edge
of the swivel base. If possible, keep the chassis casing above
water. Generally, as few components as possible should be
immersed in water. Parts that have been exposed to water for
a longer time must be subsequently lubricated until the grea-
se exits from the bearings. For additional information, refer to
the Maintenance chapter.
To Next Page
Loading...
