Page 110 www.menzimuck.com
Working with the machine
7.2 Intended use as prescribed by the manufacturer
The machine has been designed and constructed solely for the intended use
described herein:
7.2.1 Work above ground
Only use the machine for work in the open. Special additional equipment is
needed for working underground.
7.2.2 Work in general
Always position the machine supports as wide as possible. Maximum stabi-
lity can thereby be achieved. Only lift loads that do not impair the stability of
the machine. Always move the boom, the attachment and/or the load within
a swivel radius as small as possible.
7.2.3 Work on slopes
Always position the machine supports as wide as possible. Keep the machi-
ne incline as low as possible. Never risk an incline that could endanger the
stability of the machine. Only work on slopes when you are acquainted with
the machine.
7.2.4 Work on paved surfaces
When working on paved surfaces make sure that the surface is not dama-
ged. If necessary, mount the rubber pads.
To Next Page
Loading...
