Mercury 200 VERADO User Manual

FEATURES AND CONTROLS
50
4. Detent tension adjustment screw - This screw can be adjusted
to increase or decrease the effort to move control handle out
of detent positions (cover must be removed). Turning the
screw clockwise will increase tension. Adjust to the desired
tension.
a
b
ob01170
+
-
a - Detent tension
adjustment screw
b - Control handle tension
adjustment screw
5. Start/stop button - Allows the boat operator to start or stop the
engine without using the ignition key.
6. Neutral LED - The neutral LED illuminates when engine is in
neutral gear position. It also flashes when throttle only is
activated.
NOTE: Gear position is determined by sensing the position of the
shift actuator on the engine, not the position of the control handle.
7. Active LED - The active LED illuminates to show the remote
control is active and ready for use.

Mercury 200 VERADO Specifications

General

Engine Type	4-Stroke
Gear Ratio	1.85:1
Full Throttle RPM Range	5800-6400 RPM
Fuel System	Electronic Fuel Injection (EFI)
Exhaust	Through Prop
Horsepower	200 HP
Fuel Induction System	Electronic Fuel Injection (EFI)
Shaft Length	20", 25"
Starting	Electric
Fuel Type	87 Octane
Cylinder Configuration	Inline-6
Cooling System	Water-cooled with thermostat