EasyManuals Logo

Mercury Sterndrive QSD 2.0 User Manual

Mercury Sterndrive QSD 2.0
131 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #69 background imageLoading...
Page #69 background image
Section 5 - Maintenance
90-8M0069751 eng APRIL 2012 Page 61
3. Add the specified fluid to bring the fluid level to within the "MIN" and "MAX" lines on the reservoir.
a - Reservoir
b - "MIN" and "MAX" lines
Tube Ref No. Description Where Used Part No.
114
Power Trim and Steering
Fluid
Power trim pump 92-858074K01
4. Install the fill cap.
Changing
Power trim fluid does not require changing unless it becomes contaminated with water or debris. Contact your Mercury Diesel
authorized repair facility.
Power‑Assisted Steering Fluid
IMPORTANT: Use only Quicksilver Power Trim and Steering Fluid or Dexron III automatic transmission fluid (ATF) in the
power‑assisted steering system.
IMPORTANT: Running the pump dry will damage the pump. Always check steering fluid levels before operating the boat.
Checking
1. Center the sterndrive and stop the engine.
2. Remove the fill cap and dipstick from the fluid reservoir and observe the level.
a. The proper fluid level with the engine cold should be between the full cold mark and the end of the dipstick.
b. With the engine at normal operating temperature, the fluid level should be between the full hot and full cold marks.
Typical
a - Fill cap and dipstick
b - Full hot mark
c - Full cold mark
d - Fluid reservoir
a
b
7876
13064
a
b
c
d

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury Sterndrive QSD 2.0 and is the answer not in the manual?

Mercury Sterndrive QSD 2.0 Specifications

General IconGeneral
BrandMercury
ModelSterndrive QSD 2.0
CategoryEngine
LanguageEnglish

Related product manuals