Section 5 - Maintenance
Page 52 90-8M0069751 eng APRIL 2012
Tube Ref No. Description Where Used Part No.
121
15W40 4-cycle Diesel
Engine Oil
Oil filter O-rings 92-858042K01
16. Push the filter element into the cover until it is locked. Listen for a click.
Engine coolant oil cooler Seawater oil cooler
a - Oil filter cover
b - O‑ring
c - Filter element
17. Install the cover with the new filter element into the oil filter housing. Turn the oil filter cover until the sealing surface
contacts the housing.
18. Tighten the cover to specification.
IMPORTANT: Overtightening the cover may cause an oil leak.
Engine Coolant Oil Cooler
Description Nm lb–in. lb–ft
Engine oil filter housing cover 25.0 – 18.0
Seawater Oil Cooler
Description Nm lb–in. lb–ft
Engine oil filter housing cover 22.5 – 16.0
19.
Remove the oil fill cap and refill the engine with new oil. See Filling.
IMPORTANT: When refilling the engine with oil, always use the dipstick to determine how much oil is required.
20. Replace and secure the oil fill cap.
21. Start the engine and check for leaks.
Alpha Sterndrive Gear Lube
Sterndrive Gear Lube
NOTICE
Discharge of oil, coolant, or other engine/drive fluids into the environment is restricted by law. Use caution not to spill oil,
coolant, or other fluids into the environment when using or servicing your boat. Be aware of the local restrictions governing
the disposal or recycling of waste, and contain and dispose of fluids as required.
Checking
NOTE: The gear lube level will fluctuate during operation. The gear lube level should be checked with the engine cold, before
starting.
To Next Page
Loading...
Need help?
General