Section 5 - Maintenance
Page 84 90-8M0069751 eng APRIL 2012
Installation
1. Install a new sealing washer on the anode assembly (anode plug with the sacrificial anode).
a - Anode assembly
b - Sealing washer
2. Install the anode assembly and washer into the aftercooler end cover. Tighten securely.
Seawater system anode assembly location
3. Unplug and connect the seawater inlet hose, or open the seacock if equipped.
NOTICE
Without sufficient cooling water, the engine, the water pump, and other components will overheat and suffer damage. Provide
a sufficient supply of water to the water inlets during operation.
4. Ensure that both the sterndrive and engine seawater pickup pumps are supplied sufficient cooling water.
5. Start the engine and check for leaks
19227
To Next Page
Loading...
Need help?
General