68
Chapter 4 Congure the Router in Wireless Router Mode
4. Select your Client Access type. Select Home Network Only if you only want the remote
device to access your home network; select Internet and Home Network if you also want
the remote device to access internet through the VPN Server.
5. (Optional) Click Advanced Settings to display more settings. If DNS is turned on, the router
will become the DNS server of the VPN client that establishes a connection with it. Change
the Persistent Keepalive time (25 seconds by default) to send out heartbeat regularly, you
can also click RENEW KEY to update the private key and public key.
Step 2. Create accounts that can be used by remote clients to connect to the VPN server.
1. Locate the Account List section. Click Add to create an account.
2. Give a Username to this account.
3. View the Address of the virtual interface assigned to this account. Do NOT change it unless
necessary.
4. Traffic sent from the WireGard VPN client to the allowed IPs (client) will be transmitted
through the tunnel. By default, all network traffic from clients will be transmitted through
the tunnel. Do NOT change it unless necessary.
5. Traffic sent from the WireGard VPN server to the allowed IPs (server) will be transmitted
through the tunnel. Do NOT change it unless necessary.
6. Enable or disable Pre-shared Key.
7. Click SAVE.
Note: One account can only be used by one WireGuard VPN client at the same time to connect to the WireGuard VPN server.
To Next Page
Loading...
