8. Annual PM check procedure for conneX
®
Tasks: Annual Technician PM check.
Frequency: Annual.
Time to complete: 1-3 hours.
Model: Merrychef conneX
®
12e
Service procedures.
Safety information:
Please always adhere to
all Merrychef safety
aspects.
• All tests to be carried out by a trained Merrychef technician.
• Ensure all documented safety procedures are followed for each individual task.
• Refer to the relevant section within this manual for task details.
Task A.
1. Check the oven for
obvious signs of damage
and cleanliness. Switch the
oven on and off with front
switch, allow to cool down.
2. Check the power cord
and plug for damage and
replace if required.
3. Remove the air filter and
check for damage, clean
and insert or replace if
required.
4. Remove cook plate and
check for damage, clean and
insert or replace if required.
5. Inspect the cook plate supports for signs of
carbon and arching. Remove the side panels
and replace as required.
6. Check the door seal,
ensuring that it is intact,
not hanging loose or have
any sections broken away
or cracked. Replace if
required and allow silicone
to cure.
7. Remove & refit upper
impinger plate inspecting for
cleanliness and signs of
damage (if required follow the
instructions laid out in the
replacement impinger Kit).
Visually check the partition
plate for signs of
discolouration or damage.
To Next Page
Loading...
