iv. Push the node’s core out
of its case from the
opposite side. If needed,
use a non-marring tool
like a mallet to tap the
end without the handle
before reattempting.
v. As the core begins to
slide out of its case, push
on the heatsink to create
clearance. You may need
to support the core as the
batteries are quite heavy.
vi. Once servicing has been
completed, ensure the
node is off via mobile
app before inserting it
back into the case.
vii. The side of the node with
the cam handle must be
inserted last. The hollow
case is symmetrical, so it
does not matter which
side the core goes into.
viii. Stand the outer case
vertically. Lift the node
core so the cam handle
points up to the sky.
Lower it into the casing,
pushing down on the
heatsink so that it fits
inside. All wires must be
tucked into the core and
not come in contact with
the case.
To Next Page
Loading...