permanent should be sealed with caulking appropriate
for the environment.
v. Ultimate disposal of this product should be handled
according to all national laws and regulations.
vi. To prevent the system from overheating, do not operate it in
an area that exceeds the maximum recommended ambient
temperature of: 104°F (40°C).
vii. IEC 60950-1 - information technology equipment. No
components failed during any safety test.
b. Electrical safety information
i. Installation of the S618 must comply with local and national
electrical codes.
ii. Compliance is required with respect to voltage, frequency,
and current requirements indicated on the manufacturer’s
label. Connection to a different power source than those
specified may result in improper operation, damage to the
equipment or cause a fire if limitations are not followed.
iii. There are no operator serviceable parts inside this
equipment. Service should be provided only by Mesh++ or
authorized reseller.
c. FCC compliance
i. Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
ii. This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including one that may cause undesired operation.
iii. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful
interference to radio communications. Operations of this
equipment in a residential area is likely to cause harmful
interference to other WiFi equipment in which the user will
be required to correct the interference at their own expense.
To Next Page
Loading...