2. Part Number Decoder
The S618’s extended part number may be helpful to reference if its
configuration needs to be verified before troubleshooting. This
number can be found on a label on the outer case of the node.
1. Model Number: S618
2. Version Number: 1 (as of January 1, 2023)
3. Hardware Revision:
a. 04: standard S618
b. 05: S618 with N-type connectors for external antennas
(additional WiFi 6E radio is required to use them, but the
node can still operate normally without it)
c. 05E: same as above; the connectors are routed to replace
the integrated 2x2 WiFi 6 antennas with external ones
4. Battery Pack(s): 1-5
5. Power over Ethernet (PoE) Capability:
a. Active (A): an active PoE injector (PSE) can power devices
through the USB-C port on the node
b. Passive (P): a passive PoE injector (PSE) can power 12V or
24V devices through the USB-C port on the node
c. Power Module (D): a Powered Device module that allows
the node to be powered or slowly charged over PoE
d. None (N): the node cannot be powered or power other
devices through PoE
To Next Page
Loading...