12
|
VIKING / VIKING COMBI
Rev. 2.0 (1.8.2017)
Operating instructions
4. Operating instructions
All personnel using the appliance must be given training in how the appliance works by the person respon-
sible for staff safety.
4.1. Before use
Check the following points before using the kettle.
4.1.1. After the installation
Check that:
• The kettle has been installed horizontally according to the installation instructions
• All connections (electricity, water and steam) are tight and correctly made.
4.1.2. Before the fi rst use
• Clean the kettle thoroughly with warm detergent solution and remove the dust and dirt with a cloth.
Dry all surfaces after cleaning.
4.1.3. Daily
Electrically heated models:
Check that:
• The kettle is in its upright and horizontal position. The kettle does not heat if it is tilted.
• The scrapers are correctly attached to the mixing tool. See “Positioning the mixing tool and scraper”.
• The mixing tool has been locked in its place: locking part (one end of the handle) in the groove of the
mixer axle, with the handle turned in a horizontal position. Secure fi xing by trying to lift the tool out of
the kettle by the upper blade.
• The steam generator has the right amount of water (white water level indicator light on the control
panel of the Viking kettle, normally water must be refi lled a few times per year).
Steam heated models:
Check that:
• The kettle is in its upright and horizontal position. The kettle does not heat if it is tilted.
• The scrapers are correctly attached to the mixing tool. See “Positioning the mixing tool and scraper”.
• The mixing tool has been locked in its place: locking part (one end of the handle) in the groove of the
mixer axle, with the handle turned in a horizontal position. Secure fi xing by trying to lift the tool out of
the kettle by the upper blade.
• Surplus condensate water has been drained off from the steam jacket as needed.
STOP
To Next Page
Loading...
