26
|
VIKING / VIKING COMBI
Rev. 2.0 (1.8.2017)
Operating instructions
4.3. After use
4.3.1. Cleaning the kettle
Use of a high pressure hose for cleaning of the kettle is forbidden.
Note that it is not allowed to spray the air inlets or the control panel with water when cleaning the kettle
with a spray gun.
Always clean the unit carefully, considering the hygienic aspects, immediately after use. Cleaning is more
easy to do and needs less water in this way.
Recommended tools for cleaning:
• Special cleaning detergents for stainless steel
• Nylon brush
• Soft rubbing sponge (white)
• Other materials meant for stainless steel which do not scratch the surfaces of the kettle
Tools not allowed for cleaning:
• High pressure hose
• All metallic tools
• Rough rubbing sponge (green)
• Steel wool
• Abrasive detergents
Cleaning procedure:
1. Chill the kettle with cold water
2. Scrape the dirt with a plastic scraper.
3. Spray detergent in the kettle, brush and wash clean with a water hose
4. Dry the kettle
Clean the outer parts of the kettle using running water only if necessary. Do not use water more than is
necessary. Cleaning with a damp cloth will often be enough.
All optional extras of the kettle such as strainer plates, mixing tools and scrapers, cooking baskets and
parts of the safety lid can be washed in a dishwasher.
The dosing and impact time instructions for cleaning detergents must be followed - e.g. exceeding the
impact time for foam cleaning detergents in combination with salt residues has been observed to cause
severe spot corrosion even on stainless steel.
The manufacturer does not take any responsibility for possible damage caused by not following the
instructions above.
STOP
STOP
STOP
To Next Page
Loading...
