6
|
VIKING / VIKING COMBI
Rev. 2.0 (1.8.2017)
Safety
2. Safety
2.1. General
Modifying the equipment without the approval of the manufacturer invalidates the manufacturer’s prod-
uct liability.
To further improve safety during installation, operation and servicing, the operator and the personnel
responsible for installing and servicing the appliance should read the safety instructions carefully.
Switch off the appliance immediately in the event of a fault or malfunction. The appliance must only be ser-
viced by trained engineers. The regular checks described in the manual must be carried out in accordance
with the instructions. The appliance must be serviced by a person authorized to do so by the manufacturer.
Use original spare parts. Dangerous situations may arise if the instructions above are not followed.
Before using the appliance, ensure that personnel are given the necessary training in operating and
maintaining the appliance.
Keep this manual in a safe place so that it can be used by other operators of the appliance.
This manual guides the user to use the device safely.
The appliance should not be used by anyone suffering from a physical or mental illness or by inexperi-
enced people (including children).
Children should be watched to ensure that they do not play with the appliance.
2.2. Safety features
The kettle is built for 1,5 bar pressure, and the working pressure is 1,0 bar. The working height is 900 mm,
with an exception of Viking 400 where it is 1050 mm.
The double steam jacket is isolated with a third casing jacket, throughout equipped with a foil and foam
insulation, which limits the top temperature of the outer steam jacket under the skin burn limit. The kettle
can be cleaned with a cleaning hose (IPX5). Water jets directed towards the vent holes and control panel
from a near distance should be avoided.
The kettle is fi tted with many different safety devices to ensure smooth and safe operation. The safety
equipment at the rim behind the kettle includes a pressure gauge, a safety valve and an automatic
vacuum valve. The safety valve opens if the steam pressure exceeds 1,5 bar.
A limit switch which is attached to the tilting axle turns off the heating during the tilting (steam heated models)
In addition to the safety valve, the kettle has a pressure switch which operates as a backup safety device
of the safety valve. The control does not allow the steam jacket temperature to exceed 120°C. This tem-
perature corresponds to a 1,0 bar steam pressure (electrically heated models).
The water level probe in the steam generator operates as a boil dry protector. In case of insuffi cient water
level in the steam generator, the white water level indicator light on the control panel turns on and the
kettle does not warm up. In addition, a limit switch which is attached to the tilting axle turns off the heat-
ing during tilting (electrically heated models).
Due to the safety switch which is on the safety lid it is not possible to start mixing (Viking Combi), if the
safety grid is not in position. The kettle will not tilt, if the lid is on the kettle.
2.3. Emergency/stop button
All Viking kettles are equipped with an emergency/stop button, which disconnects the control circuit
and all functions of the kettle and the mixer will be stopped. To restart the cooking/mixing, turn the
emergency/stop button clockwise until it jumps to its upper position. After this has been done, all other
switches and buttons can be activated again.
STOP
STOP
STOP
To Next Page
Loading...
