Metos 40E - Page 24

24
|
VIKING / VIKING COMBI
Rev. 2.0 (1.8.2017)
Operating instructions
Basic mode
• The appliance is on when the kettle on-off switch is on; 0 appears in the last digit’s position.
• Decimal point is illuminating.
• The set amount of fi lling has been achieved. The values are 0.
• If the function of the appliance is interrupted by switching off the control voltage, the switching on
again will always set it to this basic mode.
Manual water fi lling
• Filling starts when the button is pushed and held down for the duration of fi lling.
• The display is updated with an accuracy of one liter as long as the button is held down.
• The achieved value in liters is shown on the display for 10 seconds after stopping the fi lling. Then 0
appears on the display.
• If you want to continue fi lling within the mentioned time, the value on the display will continue in-
creasing.
Automatic fi lling of water
• Set the desired amount by pushing the -button (4). The set value appears on the display.
• The value can be decreased by using the button (5).
• The value is shown on the display for 10 seconds after which the set value will be 0.
• Start the fi lling by briefl y pushing the button while the set value is illuminating on the display.
• After starting the fi lling function, the display will cumulatively show the amount of water fi lled (in
liters) and the fl ow stops automatically when the set value has been achieved. The set value is reset
to zero.
• The amount of water fl own will stay on the display and the appliance reverts to the basic mode by
pushing either or .
Interrupting the automatic fi lling of water
• The function is interrupted by pushing the automatic fl ow on/off button.
• The achieved value stays on the display and the decimal point is blinking.
• The set value is saved in the memory.
• In the interrupted mode, the setting can be changed using the and buttons.
• The water dispenser reverts to the basic mode by pushing either or .
• If the function is interrupted by pushing the emergency-stop button, the appliance reverts to the basic
mode and the settings must be done again.
Continuing the automatic water fi lling after interruption
• The fi lling will continue from the achieved value up to the set value by pushing the button.
• After this the decimal point will illuminate continuously.
Error in automatic water fi lling
• If there is an error in fl ow measurement or if water does not fl ow, the value on the display blinks.
• The water dispenser reverts to the basic mode by pushing either or .