154
Operation complete
*OPC <cr>
This command sets the OPC bit in the ESR (Event Status Register) when all pending operations are
complete.
Operation complete?
*OPC? <cr>
This command returns “1” to the output queue after all pending operations are complete.
Operation complete?
*OPC? <cr>
This command returns “1” to the output queue after all pending operations are complete.
Wait-to-Continue command
*WAI <cr>
Prevents the instrument from executing any further commands or queries until all previous remote commands
have been executed.
Reset
*RST <cr>
This command resets the calibrator to its initial status.
Test operation
*TST? <cr>
This command executes an internal self-test. Return the self-test result (“0” for pass or “1” for fail).
Status byte reading (IEEE488 only)
*STB? <cr>
This query returns the Status Byte Register including the MSS bit.
Service Request Enable setting (IEEE488 only)
*SRE <value> <cr>
This command sets condition of the Service Request Enable register. Since bit 6 is not used, the maximum
entry is 191.
Service Request Enable reading (IEEE488 only)
*SRE? <cr>
This query returns the Service Request Enable Register.
Event Status Register reading (IEEE488 only)
*ESR? <cr>
This query returns the contents of the Event Status Register and clears the register.
Event Status Enable setting (IEEE488 only)
*ESE <value> <cr>
This command programs the Event Status Enable register bits. If one or more of the enabled events of the
Event Status Enable register is set, the ESB of Status Byte Register is set too.
To Next Page
Loading...
