6.1 Creating a titration method
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
32
￭￭￭￭￭￭￭￭
916 Ti-Touch
￭ Close the dialog for the calculation by tapping twice on [ ]. You
will now see once again the dialog with the three commands.
Defining the report output
1
Open the report command
￭ Select the REPORT command and tap on [Edit command].
Two reports are already specified. According to these parameters,
a result report and a titration curve will be printed out automati-
cally after each determination.
2
Modify the result report
￭ Select Result report and tap on [Edit].
Here you can select the data which will be printed in a result
report.
￭ Select additional data (e.g. Sensor data and Titrant data) by
tapping accordingly.
￭ Close the dialog with [
].
To Next Page
Loading...
Need help?
General
