MG 43 Series - Page 22

2243DV2 EM-9422-B Rev.3
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
■ BASIC SETTING PROCEDURE
The basic setting procedure is as follows.
1
Conrm the wiring, turn on the power and move on to Scaling Setting Mode (measurement stopped).
• Hold down S
C button for 3 seconds or more.
2
Set display scaling value A.
• Press S
F button to shift the display into the setting standby mode.
• Press S
F button to go to the next digit and UP button to change the blinking value.
3
Set display scaling value B.
• Press D
I or SC button to apply the new setting and go to the next or previous parameter setting.
• Press S
F button to shift the display into the setting standby mode.
• Press S
F button to go to the next digit and UP button to change the blinking value.
4
Set decimal point position.
• Press D
I or SC button to apply the new setting and go to the next or previous parameter setting.
• Press S
F button to shift the display into the setting standby mode and UP button to select the decimal point position.
5
Return to Measuring Mode (measurement started).
• Hold down D
I or SC button for 1 second or more to apply the new setting and return to Measuring Mode.