Operating Instructions Synchroprint 5000
Operating instructions SP5000 V1-0.docx Page 10 of 52
1.8. Safety Signs on the Machine
The following safety signs are attached to the corresponding points of the machine:
Warning against squashing of parts
of the body, in particular arms or
hands.
Warning of dangerous voltage.
At current-carrying parts of the
machine with 230/400VAC.
The adhesive labels must be replaced if illegible (due to dirt or damage).
1.9. Other Valid Rules and Regulations:
The customer must comply with all regulations applicable in the country where the machine is
located.
2. Intended usage of the machine
The machine is intended for the printing of substrates (usually textiles such as T-shirts, but also
paper or similar materials) by means of screen printing. The substrates are conveyed by means of
the “carrousel system”. With the use of optional accessories the substrate can also be dried or
treated with other finishing techniques (e.g. flocking).
Any other use of the machine than described above may result in danger to
persons or material damage and is therefore forbidden.
To Next Page
