MHM SYNCHROPRINT 5000 - Shutting Down the Synchroprint; Switching Off the Machine after Normal Operation; Long-term Shutdown; Permanent Shutdown of the Machine

Operating Instructions Synchroprint 5000
Operating instructions SP5000 V1-0.docx Page 49 of 52
11. Shutting Down the Synchroprint
11.1. Switching Off the Machine after Normal Operation
The following procedure must be observed when switching off the Synchroprint after normal
operation:
 Clean all print stations.
 Shutdown the machine by using “Control ON/OFF.
 Switch off tablet with “Main switch tablet”.
 When required disconnected machine from mains by the main power switch.
11.2. Long-term Shutdown
This refers to a scheduled long-term shutdown of the Synchroprint.
The following procedure must be followed:
 Remove all the printing screens along with the pallets.
 Lower the print stations at menu ADJUST with the button UP/DOWN.
 Switch off the compressed air supply.
 Shutdown the machine by using “Control ON/OFF.
 Switch off tablet with “Main switch tablet”.
 Disconnected machine from mains by the main power switch.
 Shutdown control unit by main control switch and wait until Touch screen switches off
 Disconnect the power supply.
 Carry out thorough cleaning of the machine.
 Carry out any necessary maintenance work.
11.3. Permanent Shutdown of the Machine
If the Synchroprint is to be permanently shut down or decommissioned (e.g. disposed of/scrapped),
upon disassembly all individual parts must be disposed of according to their class and substance,
and in accordance with any respective regulations in effect at that time in the machine’s particular
location/country, and by a suitably reputable and authorized waste-disposal company.
If the compressed air supply is turned off (e.g. overnight), the print stations
will lower or drop uncontrolled. In this case the turntable must not be moved
after the shutdown in order to prevent damage to the main registration
blocks/points of the machine. This would result in the cancellation of the
warranty.