Easidew PRO XP User’s Manual
Michell Instruments vii
Safety
The manufacturer has designed this equipment to be safe when operated using the procedures
detailed in this manual. The user must not use this equipment for any other purpose than that
stated. Do not apply values greater than the maximum value stated.
This manual contains operating and safety instructions, which must be followed to ensure the safe
operation and to maintain the equipment in a safe condition. The safety instructions are either
warnings or cautions issued to protect the user and the equipment from injury or damage. Use
qualifi ed personnel and good engineering practice for all procedures in this manual.
Where this symbol appears in the following sections it is used
to indicate areas where potentially hazardous operations need
to be carried out and where particular attention to personal and
personnel safety must be observed.
Toxic Materials
The use of hazardous materials in the construction of this instrument has been minimized. During
normal operation it is not possible for the user to come into contact with any hazardous substance
which might be employed in the construction of the instrument. Care should, however, be exercised
during maintenance and the disposal of certain parts.
Long exposure to, or breathing of the calibration gases, may be dangerous.
Repair and Maintenance
The instrument must be maintained either by the manufacturer or an accredited service agent. For
Michell Instruments’ worldwide offi ces contact information go to www.michell.com.
Calibration
Prior to shipment, the analyzer undergoes stringent factory calibration to traceable standards. Due
to the inherent stability of the instrument, regular fi eld calibration should not be required under
controlled operating conditions. However, Michell Instruments recommends that a calibration be
considered at intervals of every 12 months of the instrument’s life.
Michell Instruments can provide a fully traceable factory calibration service. Please contact your local
Michell Instruments’ offi ce or representative for further details (www.michell.com).
Otherwise the analyzer should perform reliably for many years with just basic maintenance and
housekeeping.
Safety Conformity
This product carries the CE mark and meets the requirements of relevant European safety directives.
To Next Page
Loading...
Need help?
General
