© Microhard Systems Inc. CONFIDENTIAL 71
IP9xx Series
6.0 Configuration
6.1.4.5 Bridge Configuration
In most deployments, Spanning Tree Protocol (STP) will not be re-
quired. It does consume a small amount of bandwidth. The default
is ‗On‘. If desired, change the status to ‗Off‘.
Note that this menu item will not appear if the IP Series unit is config-
ured to be a router.
STP: Spanning Tree Protocol
is a link management protocol
which will accommodate the
availability of redundant data
paths but inhibit the possibility
of a loop being created: a
loop could create endless
traffic ‗around‘ a LAN,
consuming much of the
bandwidth.
Spanning Tree Protocol Status
Selection of STP operational status within the IP Series: On or Off.
On
On
Off
Values
Image 6L: Network Configuration, Bridge Config. Submenu
Soft Buttons
Submit
Write parameter values into IP Series memory.
Reset
Restore ‗currently‘ modified parameter values to those
which were previously written into IP Series memory.
To Next Page
Loading...
