Microhard Systems IP-921 - Quality of Service

© Microhard Systems Inc. CONFIDENTIAL 72
IP9xx Series
6.0 Configuration
6.1.4.6 Quality of Service
Quality of Service (QoS) may be applied to various data which enter
the IP Series. This section describes configuring QoS for data which
enters via the ethernet port.
Image 6M: Network Configuration, Quality of Service Submenu
Quality of Service Status
If Enabled, the defined protocols and ports will have the QoS
service applied to them.
Disable
Disable
Enable
Values
To define particular ports, protocol, and priority to be assigned, see
the example of such a configuration exercise on the following page.
QoS: Quality of Service is
applied to networks where it
is desired to give particular
data traffic/protocol(s) priority
over other data traffic.