IP920 Operating Manual iii
Regulatory Requirements
WARNING
To satisfy FCC RF exposure requirements for mobile transmitting devices, a separation distance of 23 cm or
more should be maintained between the antenna of this device and persons during device operation. To
ensure compliance, operations at closer than this distance is not recommended. The antenna used for this
transmitter must not be co-located in conjunction with any other antenna or transmitter.
WARNING
This device can only be used with Antennas listed in Appendix E. Please Contact Microhard Systems Inc. if
you need more information or would like to order an antenna.
WARNING
MAXIMUM ERP
FCC Regulations allow up to 36 dBm effective radiated power (ERP). Therefore, the sum of the
transmitted power (in dBm), the cabling loss and the antenna gain cannot exceed 36 dBm.
WARNING
EQUIPMENT LABELING
This device has been modularly approved. The manufacturer, product name, and FCC and Industry
Canada identifiers of this product must appear on the outside label of the end-user equipment.
SAMPLE LABEL REQUIREMENT:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received including interference that may cause
undesired operation.
FCCID: NS904P10
IC: 3143A-04P10
To Next Page
Loading...
Need help?
General