40 IP920 Operating Manual: Chapter 4 Configuration
Package Upgrade from Command Line FTP
This section describes the procedure to upgrade an IP920 unit with package
upgrade file (*.pkg).
Download upgrade package and put it into a known directory;
Start up a command line window from the system;
Change current directory to where the package file is located;
Start a FTP session as shown below;
Figure 20 Command Line Package Upgrade
Provide proper user name and password to login;
Change transfer protocol to BINARY mode;
Push package upgrade file into the system with “put” command;
Package upgrade takes up to 2 minutes to complete. Wait until
“SYS” LED stop flashing.
If “SYS” LED doesn’t come back to solid ON, the unit need to be
manually restarted.
To Next Page
Loading...